Materials & Products
FS3-3730
Product identification
Product identification
Use the complete product code when requesting documents, samples or a quotation.
- Full product code
FS3-3730- Matching reference
- FS3-3730 Product Profile / TDSDocument date 2011-05-11
Technical data
Typical properties and test methods
For omitted items, use the product document confirmed at request time; do not fill gaps from a similar code.
Typical data from the reference TDS
FS3-3730 Product Profile / TDS · Document date 2011-05-11
Values are shown in the document's original units. They are Typical data, not purchasing specifications. Values from different methods or conditions are not directly equivalent.
| Property | Typical value | Test method |
|---|---|---|
| Appearance | Translucent | Not stated in this document |
| Tack-Free Time | 15 minutes | Not stated in this document |
| Specific Gravity | 1.35 | Not stated in this document |
| Durometer, Type A | 35 | Not stated in this document |
| Tensile Strength | 820 psi (5.7 MPa) | Not stated in this document |
| Elongation | 400% | Not stated in this document |
| Tear Strength | 50 ppi (8.8 kN/m) | Not stated in this document |
| Lap Shear Strength | 200 psi (1.4 MPa) | Not stated in this document |
Documents & lot records
Technical and lot documents
Request the current product documents and any lot-specific records required for your project.
- Product Profile / TDS referenceThe date identifies the reference used on this page; it does not establish the current revision, supply or a regulatory conclusion.FS3-3730 Product Profile / TDS · Document date 2011-05-11
- Lot documentsIf the project requires a CoA or another lot document, state it in the inquiry. Availability is confirmed for the code and actual lot.Available records depend on the product and lot
Using product information
Selection and validation
- Typical data supports technical discussion; it is not a purchasing specification.
- Material-level information is not finished-device approval. Suitability depends on the exact code, contact conditions and final device validation.
- Lot documents apply to a specific production lot. Confirm current documents before design or acceptance.
Discuss your application
Submit FS3-3730 and application details
Tell BIO about the component, contact conditions, process, expected volume and documents you need. Request application support, samples or a quotation.